The Rapid Splitter's Oil Spill Solution


With the development of the economy, the application range of Rapid Splitter has become wider and wider.

  With the development of the economy, the application range of Rapid Splitter has become wider and wider. When processing materials, they usually run for a long time and have a large processing capacity. This directly leads to the use of dryers. There are more or less large and small problems, these problems will affect the normal use of the equipment. Oil leakage is a common problem in the operation of dryers. So, how do we avoid and solve this problem? The editor proposes the following suggestions for you:


   (1) During operation, due to the failure to clean up in time, some oil holes on the oil pipeline are easily blocked by the slag of the material, which causes the oil pressure in the oil pipe to rise and the oil volume to increase. The amount of oil injected by the oil ring increases and it is easy to splash. The outside of the equipment will cause oil leakage inside and outside the entire dryer. Therefore, in this case, the equipment must be cleaned and cleaned in time to clean the injection holes.

   (2) When injecting fuel, the fuel injection valve becomes larger and the fuel injection amount is large. Under normal circumstances, the oil will fall from the fuel injection hole to some crankshafts inside the equipment. At the same time, the operation of the equipment will cause oil pollution. Splashes will cause the drying quality of the equipment and difficult operation. In view of this situation, it is necessary to require professional and technical personnel to fine-tune the oil injection link of the equipment to ensure that the equipment is lubricated normally under the premise of normal oil injection and lubrication, and will not cause oil shortage and oil temperature to affect the equipment. Happening. There are also some factors, because when the dryer is lubricated, the oil will be thrown out of the oil leakage ring, which will cause the oil leakage of the entire equipment. To avoid this, the Log Splitter is located between the oil ring and the oil hole. The installation of the rubber plate can completely isolate the splashes from the oil splash. It is also possible to increase the total area of ​​the oil injection hole by replacing the parts of the entire equipment to ensure that the lubrication of the oil shaft will not cause blockage and oil leakage of the equipment.

21 الآراء