How To Install The V-belt


Correct use of triangular belts

V-belt (also called V-belt) is a standard part, produced by a professional factory. For V-belt (V-belt),

Correct use of triangular belts

V-belt (also called V-belt) is a standard part, produced by a professional factory. For V-belt (V-belt), according to the size of its section, the original standard is divided into O, A, B, C, D, E, F seven There are seven models, the new standard is divided into Y, Z, A, B, C, D, E, seven models, and their cross-sectional dimensions increase sequentially. The commonly used triangle tapes are Y, Z, A, and B. The replaced triangle tape should be consistent with the model of the pulley groove, and the length of the replaced triangle tape and the original triangle tape should be equal to the length required by the design (the model and inner circumference of the triangle tape are stamped on the outside of the tape. Observe carefully). When selecting, choose different types of V-belts according to the power and the size of the pulley groove.

V-belt installation

Note during installation: the axes of the main and driven pulleys should be kept parallel; the grooves must be in the same plane and must not be twisted; the tension of the triangle tape must meet the requirements; when multiple triangle belts are driven, the length and tension of each Should be basically the same; and a protective cover should be installed. Before installation, ensure that the two planes of the driving wheel and the driven wheel are on the same plane. When installing the V-belt, it is not allowed to use iron tools to forcibly pry in. This will seriously damage the pryed part of the V-belt. It may also pry the V-belt pulley groove. The correct installation method is: first loosen the tensioning device, then press the V-belt into the pulley groove by hand, and finally tighten it. hexagonal belts are also our product, please consult and contact us for details of installation and use.